Can anyone using a Burny Phantom control for cnc plasma cutters tell me where I can control the lead-in-out cut pattern? For example: when burning a .590Ø hole I want to lead straight into the circle from the center, and lead out with an arc. I'm trying to minimize the distortion from the pierce points to achieve a cleaner more uniform hole.
Results 1 to 2 of 2
-
09-01-2011, 07:26 PM #1
Registered
- Join Date
- Mar 2011
- Posts
- 5
Changing lead-in-out for cnc plasma cutters?
-
09-29-2011, 05:35 PM #2
Registered
- Join Date
- Sep 2006
- Posts
- 204
I have software that I used to use to program a Burny 10. We ended up doing a lead in with an arc and then created a gap at the end rather than a lead out.
Independent CNC Programmer
www.independentcnc.com
My mission is to share CNC programming innovations for a lifetime.
Reply With QuoteSimilar Threads
-
Plasma cutters suck!
By aaronbee in forum Plasma, EDM / Other similar machine Project LogReplies: 19Last Post: 05-29-2011, 06:02 PM -
Changing from Timing Belts to Lead Screw X and Y axis
By Schweinhund227 in forum DIY CNC Router Table MachinesReplies: 6Last Post: 03-19-2009, 05:48 PM -
plasma cutters
By jimstoybox in forum Waterjet General TopicsReplies: 1Last Post: 01-07-2009, 12:00 AM -
Plasma cutters (What should I look out for? )
By ynneb in forum Waterjet General TopicsReplies: 5Last Post: 09-19-2008, 02:50 PM -
Clueless about plasma cutters
By Blacksunshine in forum Waterjet General TopicsReplies: 3Last Post: 09-02-2008, 03:13 AM
Posting Permissions
