[Glass]

hi,

did you get your problems sorted? If not give me your email and I will be able to help.

Also have instruction manuals for cad-cam which I can send.

[MyMind]

I got help from Jan and most of my problems are resolved

Only program transfer from PC to CNC still unsolved, but I think it is something wrong in windows settings.

Solved problems:
I got this German manual to CAD/CAM bevel 3.44 and find the mysterious F5 key to put X and Y value so I can choose the seropoint and do not need to install every time stops.

B-axes was skewed so I clocked it direct and set values to F25 and F19 so that pin can be inserted...

I do not remember actually T number problen... No problem there...

[MyMind]

spindle spinning speed goes over 10'000 r/min I get message no tool in spindel and machine turns power off. This same problem appears shometimes lower spining speed. ("Control on" starts mashine and it is redy when axes is reseted)

It is not good that galss loses suction and tool stops in it and I can't use small tools that requires more than 10'000r/min.

I think there is shome sensor failure or tool clamp is worn.

Anyone knows what can be done if spindle clamp is worn or if the sensor replaceable?