Quote Originally Posted by WallyL7 View Post
The simple answer is just use multiple paths on a single contour. Add enough passes to compensate for the amount of removal per side and you are done.

So, if you have 1" of stock to remove on a contour (per side) and you take a .25" cut, just put 4 rough passes at .25" per pass. Comprendo?

Super quick, super simple.
Ive done that plenty of times. I was just hoping for something a little more efficient. If the contour doesnt have the same shape as the stock, it tends to cut a lot of air.

What MC release did they start their feature based machining? I have that on Featurecam, and it is great at reducing program generation times, and makes efficient toolpaths.