587,829 active members*
2,647 visitors online*
Register for free
Login

Thread: Who else is running DeskCNC?

Results 1 to 20 of 32

Hybrid View

  1. 11-17-2011, 03:26 PM #1
    Harry_Y
    Harry_Y is offline Registered
    Join Date
    Sep 2011
    Posts
    0
    Update: The feature is not currently in there, but it may be added.

    This should make it easier than having to start
    the software and select the proper profile to use.

    This is something that one would need even
    if you use two boards in the same PC.
    Reply With Quote Reply With Quote
  2. 12-16-2011, 09:56 PM #2
    Harry_Y
    Harry_Y is offline Registered
    Join Date
    Sep 2011
    Posts
    0
    FYI: I just switched over to EMC to control the machines.

    It was the easier route to get to where I wanted to be
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. DeskCNC
    By cncadmin in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 19
    Last Post: 05-11-2013, 09:37 PM
  2. running emc as a simulator, running out of ideas
    By CaptainVee in forum LinuxCNC (formerly EMC2)
    Replies: 59
    Last Post: 10-13-2012, 10:52 PM
  3. Deskcnc
    By pfiat in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 1
    Last Post: 09-09-2009, 07:03 AM
  4. DeskCNC: need help!
    By flo1084 in forum CNC (Mill / Lathe) Control Software (NC)
    Replies: 2
    Last Post: 11-19-2007, 01:20 AM
  5. deskcnc
    By natchez in forum DeskCNC Controller Board
    Replies: 1
    Last Post: 01-02-2006, 09:57 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules