Hello all, looking for help
We have MH40 OKK WITH MITSIBISHI CONTROL, the tapping mode G84 not been recognized by the machine control. The synchronies tap in parameter is on, I am getting alarm p232 not sure what it is, since no manual book in place. If anyone had gone through this before, I also tried G84.2. /G84.1 Nothing happened.
Thanks in advance for any help
Thanks
Sam
Thread: need help
Results 1 to 7 of 7
-
11-17-2011, 02:05 AM #1
Registered
- Join Date
- Aug 2010
- Posts
- 0
need help
-
11-17-2011, 02:43 PM #2
Registered
- Join Date
- Aug 2010
- Posts
- 0
canned cycle not working , any idea . parameter number?
thanks
-
11-17-2011, 04:31 PM #3
Registered
- Join Date
- Jun 2011
- Posts
- 17
Try taking synchro tapping off.You can program this control two ways for tapping: Rpm times pitch = feed in inches per minute or E for standard pitch or M for metric.Example: 1/2-13 tap E13 for M10 X1.5 M1.5. Never liked synched tapping with mitsubishi controls.
-
11-17-2011, 04:34 PM #4
Registered
- Join Date
- Jun 2011
- Posts
- 17
Sorry ,I still think you should use G84.What type of mitsubishi is it the Meldas?
-
11-17-2011, 04:37 PM #5
Registered
- Join Date
- Aug 2010
- Posts
- 0
it is Meldas 500 Mitsibishi control
-
11-17-2011, 04:47 PM #6
Registered
- Join Date
- Jun 2011
- Posts
- 17
Try putting a G99 at the beginning of the tapping cycle:Ex.1/2 -13 one inch deep @ 100rpm
G99 G84 z- 1.R.3 F7.692S100 use R1 at the end for rigid tapping or leave it out if using a tapping head.
-
11-17-2011, 05:48 PM #7
Registered
- Join Date
- Aug 2010
- Posts
- 0
problems fixed
i had to format the memory to get it work , go to machine parameter change fix-p to 1 and go to input page : enter #(4) and press input
power off
problems solved
thanks for you help
Reply With Quote
Posting Permissions
