Freinds,
I have a mori seiki mill with YASNAC control MX1(MV 35/40). When Power On Button is pressed then there is no display on the CRT. I have checked power supply and found 5V,12V and 24V are all OK. When I look inside the CRT then there is a little red light on the CRT. Fuse is ok in the CRT.
Any idea what is the problem?
How to check wheather CRT is not working or some other PCB
Warm Regard to Every one
Results 1 to 1 of 1
-
01-01-2012, 02:33 PM #1
Registered
- Join Date
- Nov 2006
- Posts
- 53
Mori Mill MX1 MV 35/40 CRT Problem
Reply With QuoteSimilar Threads
-
Mori MSG 501 (FS 18i-MA) BOOT UP PROBLEM
By L. Sakthivel in forum FanucReplies: 1Last Post: 08-18-2019, 10:31 AM -
mori seiki FL-2 problem
By cnyttbircan in forum Mori Seiki lathesReplies: 4Last Post: 10-21-2013, 09:58 PM -
problem in MORI SEIKI SL-0
By metoaly in forum DNC Problems and SolutionsReplies: 0Last Post: 10-07-2009, 07:03 PM -
Mori SL0-B with Fanuc 3T-c Problem
By andrewgore in forum FanucReplies: 5Last Post: 03-03-2008, 03:55 PM -
mori seiki mill with a spindle problem
By imwllc in forum Uncategorised MetalWorking MachinesReplies: 3Last Post: 06-27-2005, 12:31 AM
Posting Permissions
