the instructions say go to setting screen, to 8000 and set PWE to 1 and then enter your parameters. if you enter communication parameters first you should then be able to load your pre-saved parameters from a PC via rs232
when i on machine: only show this message
F10T9B 1260E
RAM TEST :END
ROM TEST: END
SERVO ROM TEST :END
LOAD SYSTEM LABEL:END
CHECK SYSTEM LABEL:PASS
IMPROPER NUMBER OF AXIS
We use cookies to optimize our website for you and to be able to improve it continuously. By clicking the "Accept" button, you expressly agree to the use of cookies. For further information on cookies, please refer to our privacy policy.