When I was connecting the DC out of the PS to the terminal blocks it dawned on me that each driver should have it's own supply (no daisy chaining), so, since I was on a roll I installed jumpers so all the motors were fed from the two terminal strips.

Then..

Later when I thought about it I realized that the PMDX-134 Geko board is supplied by a single pair. So I pulled out the jumpers and used the terminal blocks for 115v supply for the cabinet and to break out the contactor coil wires.

Click image for larger version.  Name: 100_0238sm.jpg  Views: 63  Size: 268.9 KB  ID: 149954

I also installed the ground bar and some basic support for the panel which will provide cable support.

Click image for larger version.  Name: 100_0237sm.jpg  Views: 49  Size: 255.9 KB  ID: 149955

I chose to mount the equipment on the side walls not only for saving space but also to seperate the power side from the logic side in case I need some sheilding. If I construct the final box with this in mind I will make access provisions. As it is now I have to unscrew a side panel.

BobL.