[pcreek]

Hi
When I make a simple drilling and tapping prog on my VMC Mazak with mazatrol M32 control, it gives me a following alarm.
"844 not found prog no"
"An attempt was made to call sub program which was not yet registered"
"Action: Register sub program"
Can any one advice me how to register the sub programs or I am missing any data or parameters.
Thanks

[mbi]

Make your sub program first.

[pcreek]

Thanks MBI.
Any example how to write a sub program for tapping.
Thanks

[mbi]

You may be confusing a program and a sub program. they are the same thing. Make a Mazatrol program of your tapping unit and put a end unit on it. Make another Mazatrol program containing a subprogram unit in it. place a offset unit in the main program before the subprogram unit and then you can offset and/or rotate the subprogram.

[Leemac]

You may be confusing a program and a sub program. they are the same thing. Make a Mazatrol program of your tapping unit and put a end unit on it. Make another Mazatrol program containing a subprogram unit in it. place a offset unit in the main program before the subprogram unit and then you can offset and/or rotate the subprogram.

Bumping an old one here but I'm having the same issue. Alarm 844. Made another mazatrol program containing the sub program but no success. When you say put an offset do mean a wpc? Or do i put the wpc in the drilling program and an offset in the main program? I have attached photos of the 2 programs. Any thoughts?

[mbi]

Bumping an old one here but I'm having the same issue. Alarm 844. Made another mazatrol program containing the sub program but no success. When you say put an offset do mean a wpc? Or do i put the wpc in the drilling program and an offset in the main program? I have attached photos of the 2 programs. Any thoughts?

In Pro 2
Line 2 remove repeat (make it blank)
Line 3 (end unit) make it all zeros

Pro 1 ok