After scrounging together some parts for the prototype CB I began wiring it up today.
I hope I'm not screwing it up too bad. In the picture below you can see the shunt resistor for the panel mounted amp meter.
Does this look right?
The terminal blocks will feed the Geko drives.
I have a longer cable coming for the PMDX-134 Geko motherboard to connect to the PMDX-126 below it.
In the picture below the outlet nearest the PMDX stuff will feed the router. The double box contains a connector to feed the box and next to it is a switch. Above the switch is a fuse. I probably should have wired up the fust before the switch.
Which way is correct?
Next I need to hook up the 120v contactor coil connections via the e-stop circuit.
BobL.