Originally Posted by
KnotsAboutWood
Hi,
I'm attempting to wire up a Z zero plate and after some discussion on the forum,
http://www.cnczone.com/forums/diy-cn...ml#post1100345
It appears that I'm getting to much noise on the pin that I'm using. It was suggested that I use a capacitor to reduce the noise, but I'm not sure how to wire it up, I'm hoping someone on the forum has had this issue, and can help.
Thanks for the help,
Hi,
I just fixed my noise problem on the Z zero auto tool set. My problem was that i was mounting my fixed tool setting height fixture on an aluminum table. I isolated the plate from the table and that fixed the probe LED flickering problem. Maybe this will help
farmertom
http://cncartwork.weebly.com/index.html