[Mad Welder]

..... in rev in high range only got 1350 rpm.....

Hi there USN and welcome....not to worry either as if the G0704's motor is like the BF20 (which I asume they're similar) they state somewhere in the manual that in rev you'll only get an average 50% of normal running RPM.....

and post loads of pics.... for those of us who prefer not to read

[USN]

Thanks Folks, That's good news on Motor. I will get pics uploaded. I need to get some tooling now. :banana:

Mitch ...

[USN]

Hello all; I have most of the stuff for conversion now. Got the Kl-5056D and the Kl -8070D drivers. Do you wire them like the 5056s ? Don't see a wiring diagram for the Digital drivers. Is it the same as the standard drivers? I got the 4 axis control box. The Kl-4813 Power Supply is a tight fit in the box, but I can get it in there. I might have to trim the base a bit. Should I use the same shielded wire for wiring the inside of the Box ? I downloaded info on all the stuff I got. Do I need the ProTuner software for tuning motors? I know Mach 3 does that too.

Lots of ? Sorry..... Mitch (USN)