Wow I am thinking this must be the hottest tip out there. But I never see the software any Place but Westec and this last one was the first time I have ever seen them.

So no training needed or support that is great.

So Nervis1 you went out and bought Mastercam and Onecnc for a hobby that is cool.
One hell of a hobby.

Bottom line I think they both have there place and I am for sure Bios of Mastercam.
But I truly would go back to my statement have both Dealers do a demo with the kind of work you do.

How easy is it to get training and support when needed these are important for any software’s.

Mastercam can for sure do all what I have read here.

I can safely say I do not know about oneCNC as they never show up in my part of the state except for the show. But if it is as easy and as good as you guys are saying should see it some were soon.

Have fun but really be picky and try both to see what works best for you.