[gerfmate]

HELP HELP HELP!!
I JUST BOUGHT A BRAND NEW DOOSAN DNM650 VMC, AND AM USING CIMCO EDIT PROFESSIONAL WITH A DNC PORT ,
THE ISSUE I HAVE IS THAT WITH THE CURRENT DNC SETTINGS I HAVE FOR MY CHEVALIER 2040 WITH A FANUC OIMB WITH THE SETTINGS AT 9600,7,E,1 WITH THE FIFO BUFFER OFF AND THE XON XOFF SET ON, IT WORKS FINE,
BUT WHEN I TRY AND RUN THESE SETTINGS ON THE FANUC OIMD I JUST GET PROBLEMS WITH THE FEED WHEN I TURN THE MC ON FOR THE FIRST TIME THE PROGRAM FEEDS FINE AND THEN AFTER THAT NOTHING AT ALL ITS DRIVING ME NUTS I HAVE LOST 3DAYS OF PRODUCTION , I HAVE TRIED TO PLAY WITH THE SETTINGS ON THE CONTROLLER BUT THERE ISNT MUCH ELSE ONE CAN DO UNLESS THERE IS A SETTING OR A RECOMMENDED SETTING FOR THE OIMD WHO KNOWS,
I HAVE BURNT A SOFTWARE HANDSHAKING CABLE COULD THIS BE THE ISSUE?

[robertnicolae67]

fanuc hartrol ai200 21i-mb.
system alarm
950 pmc system alarm
pc050 IOLINK ch1 4401-c400:
ma puteti ajuta cu o solutie

[gerfmate]

I HAVE FINALLY GOT THE PROBLEM SORTED , WITH THE DOOSAN DNM650 FANUC I SERIES , WHICH IS THE OIMD, WHEN YOU STOP A PROGRAM MID DNC YOU NEED TO FLIP THE SWITCH TO EDIT THEN HIT RESET BEFORE YOU CAN DNC FROM YOUR PC AGAIN, WHY DONT THESE FANUC CLOWNS MAKE A SET OF GETTING STARTED SIMPLE INSTRUCTIONS INSTEAD OF PILES OF FAT BOOKS WITH TECHNO JARBIL !!!