[aaabeee]

Hai all..
im from indonesia
this is maybe ridiclous and i have some basic question....

i have some cnc milling that run using sinumerik control, i'm not familiar with this control, and i want retrofit the just the control unto PC base mach3.

all i've got with this machine (from china) is
3 ACservodriver estun EDB-10M - run in 3phase
3 AC servo motor - run in 3 phse too

my question is, what should i control from the AC servo drive- amplifier?

can any one help me?

[Iron-Man]

Hai all..
im from indonesia
this is maybe ridiclous and i have some basic question....

i have some cnc milling that run using sinumerik control, i'm not familiar with this control, and i want retrofit the just the control unto PC base mach3.

all i've got with this machine (from china) is
3 ACservodriver estun EDB-10M - run in 3phase
3 AC servo motor - run in 3 phse too

my question is, what should i control from the AC servo drive- amplifier?

can any one help me?

Yes you can use Mach 3. The EDB-10M are position servos, see manual;
http://www.anaheimautomation.com/man...s%20Manual.pdf

You will need a PC----->BOB(Break out board)----->EDB-10M.
See pages 21, 36 and section 4.2.2 Position reference.

Hope this helps,

Iron-Man

[aaabeee]

Yes you can use Mach 3. The EDB-10M are position servos, see manual;
http://www.anaheimautomation.com/man...s%20Manual.pdf

You will need a PC----->BOB(Break out board)----->EDB-10M.
See pages 21, 36 and section 4.2.2 Position reference.

Hope this helps,

Iron-Man

Thanks Iron-Man.thanks a lot
i have a gecko g100 motion control at my desk, i want to use it to control the AC driver, do gecko g100 motioncontrol same as BOB?

about the manual , yes i have read page 36-
in another thread some say i have to feed step,direction to the driver,
and than the puls=step, and signal=Dir,is this right?

if right,
my question
there is PULS-pin25 , /PULS-pin24
SIGN-pin27, /SIGN-pin26
which pin is that i must connect to my breakout board?
is / sign will be mean invert?
or ijust follow the instruction on page36

[Iron-Man]

Thanks Iron-Man.thanks a lot
i have a gecko g100 motion control at my desk, i want to use it to control the AC driver, do gecko g100 motioncontrol same as BOB?

about the manual , yes i have read page 36-
in another thread some say i have to feed step,direction to the driver,
and than the puls=step, and signal=Dir,is this right?

if right,
my question
there is PULS-pin25 , /PULS-pin24
SIGN-pin27, /SIGN-pin26
which pin is that i must connect to my breakout board?
is / sign will be mean invert?
or ijust follow the instruction on page36

Yes, PULS = STEP and SIGN = DIR. I have not used the G100 but here is the set-up manual; http://www.machsupport.com/docs/G100....1_9-19-07.pdf

Additional info; Gecko GREX G100 Motion Controller GeckoDrive LAN / USB

Follow the set up guide and you should have no problems. Go to Mach support to find more answers.

Safety first, a run away servo can cause damage in a heart beat, so be careful.

Hope this helps,

Iron-Man