Make sure the step and direction lines aren't reversed.
Results 1 to 8 of 8
Hybrid View
-
10-07-2012, 07:00 AM #1
Registered
- Join Date
- May 2005
- Posts
- 1397
James hosts the single best wiki page about steppers for CNC hobbyists on the net:
http://www.piclist.com/techref/io/steppers.htm Disagree? Tell him what's missing! ,o)
Reply With QuoteSimilar Threads
-
SLAmStepper & BOB Construction thread
By racedirector in forum Open Source Controller BoardsReplies: 73Last Post: 04-11-2012, 02:11 AM -
SLAMStepper/Bob purchase questions...
By racedirector in forum Open Source Controller BoardsReplies: 60Last Post: 02-04-2012, 02:11 AM -
Strange things happening here in Maine!!!!
By Barefootboy4 in forum Mach Software (ArtSoft software)Replies: 1Last Post: 01-27-2011, 12:01 AM -
what are these things?
By hardwic in forum Stepper Motors / DrivesReplies: 3Last Post: 05-29-2007, 02:44 PM -
need help with a few things.
By BeeleJuice in forum Bridgeport / Hardinge MillsReplies: 2Last Post: 08-03-2006, 04:32 AM
Posting Permissions
