If prox are hooked up without resistor, the light will come on when it is triggered . If hooked up with resistor it turns into a PNP with power in line till it is triggered.
XZero cnc
ViperXZ , all 30mm rails and 5 inch travel Z axis. Closer to 6 inch travel now
http://www.xzerocnc.com/forum/showth...machine-set-up
XZero cnc
You have to set them up in mach3 , set as limit or home or both
XZero cnc
ViperXZ 1 HP ER20 spindle will have lots of vids, them will do the same with 2.7HP spindle to show difference
XZero cnc
XZero cnc
That is the new 5 inch 20mm Z axis
XZero cnc
Ill have these ones set up tomorrow and will post all info on my forum
XZero cnc
Hi, George:
My ball screw shrank during shipping? ...18mm
.
The bottom bearing house should be on the top
XZero cnc
You still get almost 5 inch travel that way too, just set soft limit there or reverse bearing houses
XZero cnc
This is how yours goes together
XZero cnc
George...
You built mine with the ballscrew on bottom on mine too
George, another question:
why the Z plate, your do not do a few mm longer? the alignment would be easier.
.
and also a slightly wider.
It would also be good, not hinder the screw head to place the spindle mount.:idea:
The viperX is very easy to do the assembly, but, must modify the Z plate.
The vast majority of buyers do not have the ability to George, for alignment.
.
I don't find that an issue myself.
The plate align almost by itself and my K2 mount bolt from the outside
Eric - DiaLFonZo
Sent from my cellphone using Tapatalk