thanks a lot man thats the best advice i have received so far and im sure i can get into the operator screen and turn off that core move inhibit thing cause i know the operator screen very well i just didnt think to look there. thanks again.
Thread: touching off core on citizen A20
Results 1 to 11 of 11
Hybrid View
-
11-08-2012, 04:46 PM #1
Registered
- Join Date
- Oct 2012
- Posts
- 0
-
11-08-2012, 06:51 PM #2
Registered
- Join Date
- Jan 2005
- Posts
- 304
To set the core you should touch off of the shank of the holder because it is straight and easy to find true center using a shim. Then measure, with an indicator the distance from the shank (ZERO) to the true tool tip. Now you will adjust the "Core" setting you got from the shank by DOUBLE this amount. VERY SIMPLE! Works EVERY TIME!
-
11-09-2012, 06:26 AM #3
Registered
- Join Date
- Oct 2012
- Posts
- 0
I ended up going into the OPR screen and turning on the core option and then I was able to use the regular core function to touch off. It works good thx for the help.
Reply With QuoteSimilar Threads
-
Touching lines do not seem 'joined'
By leprechaun in forum BobCad-CamReplies: 7Last Post: 07-13-2011, 08:30 PM -
Probe touching message
By ddgman2001 in forum FadalReplies: 3Last Post: 05-22-2011, 09:36 PM -
Touching tools off 2-4-6 block
By bjhall06 in forum Haas MillsReplies: 10Last Post: 02-21-2010, 07:59 PM -
Touching tools off of workpiece on SL-20
By vegas705 in forum Haas LathesReplies: 6Last Post: 09-23-2009, 02:14 AM -
Touching-off
By bloefeld in forum Haas MillsReplies: 4Last Post: 08-03-2008, 11:07 AM
Posting Permissions
