588,066 active members*
4,864 visitors online*
Register for free
Login

Thread: M520 assignable M-code

Results 1 to 3 of 3
  1. 11-30-2012, 07:27 PM #1
    rick kroeze
    rick kroeze is offline Registered
    Join Date
    Nov 2007
    Posts
    38

    M520 assignable M-code

    On a Fanuc you can assign up to 10 M codes to access a macro.

    Is there a similar parameter set for this control?
    Reply With Quote Reply With Quote
  2. 12-10-2012, 02:40 PM #2
    camsys
    camsys is offline Registered
    Join Date
    Jan 2011
    Posts
    0
    On your machine parameters page 5 of 10 you can turn these on.

    You will then see the Macro softkey under the machine parameters
    Reply With Quote Reply With Quote
  3. 12-10-2012, 02:51 PM #3
    rick kroeze
    rick kroeze is offline Registered
    Join Date
    Nov 2007
    Posts
    38
    Thanks camsys,

    I think I found that... ironically yesterday.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Mistubishi Meldas M520 and mighty comet tool change issue.
    By 4Rm0D in forum Mazak, Mitsubishi, Mazatrol
    Replies: 4
    Last Post: 01-25-2017, 01:01 AM
  2. M520 tool change position
    By rick kroeze in forum Mitsubishi controls
    Replies: 9
    Last Post: 12-14-2012, 04:32 PM
  3. M520 spindle stop
    By rick kroeze in forum Mitsubishi controls
    Replies: 0
    Last Post: 11-30-2012, 07:23 PM
  4. M520 on Mitsubishi mill spindle warmup?
    By rick kroeze in forum Mitsubishi controls
    Replies: 0
    Last Post: 11-30-2012, 07:21 PM
  5. meldas m520 memory option parameters
    By bob@apc in forum Mazak, Mitsubishi, Mazatrol
    Replies: 0
    Last Post: 07-31-2008, 03:45 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules