[lkenney]

Good mortning;

I would like to be able to change the tool setup sheet to refect the work offset for each tool. Just incase I have not caught any changes that I have made. Does anyone now how tro change this tempate?

and #2
Recently when selecting tools the database says that the because three new tools have added, I then have to bring up the metric tool list and then the SAE tool list will work. Drives me nuts, It doewsn't happen everytime and of course I can't get it to do it this morning. If I change tools from a square end mill to a round nosed end mill it will often happen too. This is Velocity 5. What do I need to do to fix it?

Thank you

Lowell

[mariojl]

Hi Lowell
I've been out of here for some time, just saw your post, and found and answer to first question, please find the attached file, change the extention to "SetupgenTXT.CFG" replace the original located in your C:/"Surfcam folder"/V_5.
Also you'll have to change, under "Tools/Option/Files/Setup Sheet" to "Classic"; and give it a try. Hope this will solve your troubles.
in next days I'll be looking at your Q#2
Kind regards
Mario

[lkenney]

Thank I will try it out today

Lowell