Not sure if this can be done, but I'll ask.
While running in 2-path mode, is it possible to change between the
Upper offset page and the Lower offset page without stopping the machine?
Thanks
Not sure if this can be done, but I'll ask.
While running in 2-path mode, is it possible to change between the
Upper offset page and the Lower offset page without stopping the machine?
Thanks
@Don18P
Our Doosan Z290 has 2 switches for TURRET SELECT and CRT SELECT.
TURRET SELECT = [TURRET 1] - [BOTH] - [TURRET 2]
CRT SELECT = [TURRET 1] - [TURRET 2]
While running 2-path mode I can use [ CRT SELECT ] for TURRET 1 or TURRET 2.
Heavy_Metal
The Netherlands.
@Heavy_Metal
Thanks, but this machine has no CRT select.
only Upper turret/Both/Lower turret push buttons.
It's really inconvenient to have to stop the machine to change an offset.
Press the "Both" button and it'll switch between the upper and lower controls. Then you can offset while it's running.
rpm3000 thanks.
Works perfectly!
No problem.
It actually took me like 4 months to figure that one out... :withstupi