Hi,
I have finally connected my system (see pic)but am unable to make the motors move. Not sure what to do next...
- I've configured channels (0,1,2) to outputs (8,10,12) respectively (see pic); All other setting are identical otherwise; The channels have each been downloaded manually to the board
- In the step response screen, I can get the motors to do a tiny jog (<0.5sec) but unable to do any other movements otherwise (see pic)
- No success in using the jog function in KmotionCNC either.
Help!
Thanks,
Tim
P.S. I've uploaded my I/O map from a previous post