If this is what you meant (below), it doesn't seem to work. Now it stops and starts. Before it just stuttered a bit.

So this is a cambam issue? I'd like to just say don't use arcs, but I don't see how. That seemed to work fine in lazycam, but there were too many other limitations i could not work around.

Here is a sample code section.

G61
N57 G2 X17.7024 Y3.0612 I0.0181 J-0.2493
G64
N58 G1 X17.7244
G61
N59 G2 X17.8125 Y3.0449 I-0.0005 J-0.25
G64
N60 G1 X17.8217 Y3.0414
G61
N61 G2 X17.8382 Y3.0345 I-0.0887 J-0.2337
G64
N62 G1 X17.8401 Y3.0336
G61
N63 G2 X17.9121 Y2.9832 I-0.1052 J-0.2268
G64
N64 G1 X17.9203 Y2.975
G61
N65 G2 X17.9326 Y2.9617 I-0.1771 J-0.1764
G64