I run at 200mm/ sec raster but think it can go up to 300, possibly 400

Not got much off this machine as regards photo's, most was of the older 40W machine as i was learning.

This is a concept project where a pattern for casting is built up out of slices of 3mm MDF



Direct engraving onto stainless, no Cermark or anything.



I quite like the software, very simple to use but seems to do anything I want but not done any pictures yet. It's been used mainly for special gaskets that are very hard to do any other way, things like tiny 0.5mm holes in bosses only 2mm diameter.