Just getting the mill up and running for the first time. What I have:
KL-5056D x 2 (X and Y)
KL-8070D for my Z
X and Y motors are KL23H2100-50-4B
Z motor is KL34H295-43-8A
KL-DB25RS Breakout Board
Breakout board and I am regretting this as there is no info that I can find other than a crayon drawing and a diagram showing what pins are.
Okay so my major issue was that this the motors would not move at all until I realized that the breakout board was preventing the motors from running. Fixed that and setup Mach for the E-Stop.
Now the motors will only turn CCW....
Anyone have any ideas? please