I'm trying to run Mach 3 Mill in a simulation, and the execution times for simple programs are just plain silly- an hour and 30-plus minutes for cutting a 3-inch by 1.5 inch hole in half-inch plywood?
I've got do be doing something wrong. But I dunno what.
I've tuned the motors to match the 116-ounce motors on the machine, I've tred adjusting the feed rates, and they just keep reverting back to 1. Must be the drawing I imported, but it's a simple rectangle, how tough could it be?
I've downloaded the latest pdf helpfle for Mach 3 I could find. Haven't looked at it yet but I'm headed there now. I just thought I'd ask here to see if anyone had any ideas.