Originally Posted by
tercero
It's probably been discussed many times, but, I have three 23-200-DS8 200oz unipolar motors (3vDC 3 amp hobbycnc motors from 6 years ago), that I want to hook up to a bi-polar driver board (GenY32 board). The old diagram had Bb com aA
How do I wire 8 wires uniploar into four wire bi-polar? A A+ B B+. I wrote Dave at hobbycnc and he replied there isn't a phase coil configuration diagram available.
Just a quick edit. Doing some reading and I've figured out the ends of each phase and have grouped the wires appropriately so that there's two wire per bundle, representing the beginning and ending of the phase. Now I have 4 wires (grouped as two each_. Can I now wire these 4 wire bundles to the A+A- B+B- terminals?
Tercero,
Only connect one axis for testing, after confirming correct operation turn off power and connect remaining motors.
Blue & Green to A+
Red & Yellow to A-
White & Brown to B+
Orange & Black to B-
Jeff...
Patience and perseverance have a magical effect before which difficulties disappear and obstacles vanish.