My servo system rapids at 1200+ IPM, tell me if I'm bragging, lol.
less than 10 IPM (4.2mm/s)
10-50 IPM (4.2 - 21 mm/s)
50-100 IPM (21-42 mm/s)
100 - 300 IPM (42 - 127 mm/s)
300 - 600 IPM (127 - 254 mm/s
faster than 600 IPM (254 mm/s)
My servo system rapids at 1200+ IPM, tell me if I'm bragging, lol.
"A Helicopter Hovers Above The Ground, Kind Of Like A Brick Doesn't"
Greetings From Down Under
Dave Drain
Akela Australia Pty. Ltd.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)