Can anyone suggest any ideas!!!
I have a Hurco Hawk 30 that has sat idle throughout the xmas break. On returning yesterday there is now an error message
coming up on the console "Way Lube Oil Low; Enter machine diagnostics". The machine will run for a few minutes and then
this message appears and locks up the console. Then we reboot and the same happens again. We thought we had resolved this
by cleaning out the oil pump and bleeding the pipes, but it ran for 30mins and then same error message? The oil is topped up and
there appears to be oil going into the tubes?
If anyone knows how to bypass this error or if you have experienced this before and have a solution that would be much appreciated.
Kind Regards
Mark Newton