Hey Hey! so....Ill upload some pics and videos in a bit

I ran into these problems:

1. Turcite is awesome, yet takes a while to scrape, had to buy a triblade scraper to get into the edges. Also had to buy a roller to ROLL the prussian on the way dovetail, using your FINGER gives false HIGHs and Lows....
2. I installed the spindles!! WHOOT, it was a PITA, bearings had to match, had to get pushed in very slowly with a sleeve and a dead blow. I had to buy longer spindle head bolts to feed the spindle in the head stock.

Pros:

Spindles spin like BUTTER! Barely any race noise at all, it spins for a few seconds after I stop spinning it by hand! SMOOTH! Once I get it all together I will check the runout.

I will be scraping the saddle tonight and tommorrow.

I am going to purchase 2 VFD's tonight, they have to be 7.5hp or better, so thats like 600$ a pop....The trick is that I have to find quality and something with a warranty incase something should happen, so no Cheap Chinese crapo......

More updates tomorrow