Thanks Guy's, I think Geof's convinced me that style #3 is probably the easiest to impliment. It will require me, turning my truss's on their sides and then adding some members to stabilize the two truss's vertically [it may end up looking like a trussed tower on its side when its done]. Hopefully that shouldn't take to much. I am planning to do the epoxy bed's for these rails also [ for those who don't know what I'm talking about see my other postHERE ]
This will also allow me to put my Rack on the bottom of the gantry so that it shouldn't get as much dust falling on it.
Thanks again guy's!!
Jerry
JerryFlyGuy
The more I know... the more I realize I don't
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)