Last night I finished wiring the VFD Inverter, with the help of a good friend!
The Inverter is connected to a PMDX-107 spindle control board, here are the connections for the five wires:
PMDX-107 - FWD -> Inverter FOR
PMDX-107 - REV -> Inverter REV
PMDX-107 - COM -> Inverter DCM
PMDX-107 - AOUT -> Inverter VI
PMDX-107 - AGND -> Inverter ACM
The spindle started right up when I pressed the RUN button on the Inverter!
There was some vibrations, so I removed the ER20 collet & nut. The vibrations went away! So I'll have to find a higher quality set of collets & nut!
www.widgitmaster.com
It's not what you take away, it's what you are left with that counts!