[85burban]

Was running parts when I decided to motion stop just before tool change. The table is doing just what it always does and goes to right back corner to do a safe tool change. Changed some things in program and was going to start back to cutting. Moved y + then started to move x + machine said x axis error and the power shut off so you couldn't move anything. Got power to come on and then of course you couldn't do a lot because axis weren't calibrated. So I calibrate axis and then it gets to x and it says no power to x axis and the shut power off again. You can get power on and move y, z and motivate through control but don't move x. Please somebody give me an idea

[Darko D.]

Hi,

what is full error message? Also, can you open back cabinet and look at servos, maybe you have servo error ( should be bb ).

Best regards

Darko

[85burban]

The Slicer module took a crap. Thank you for reply