Hello
The zero point of my opposed spindle is displaced. For example, I’d like to grip by 30mm but the opposed spindle grips by 28mm. How could I move the zero point at 2mm?
Thanks
Controller Shop Turn Powerline with Y-axis
Hello
The zero point of my opposed spindle is displaced. For example, I’d like to grip by 30mm but the opposed spindle grips by 28mm. How could I move the zero point at 2mm?
Thanks
Controller Shop Turn Powerline with Y-axis
Hello
Didn’t you change the jaw length under >Offset>arrow rightwards>spindle?
Regards, Heisflo