Mazak issue: I keep getting an alarm of TNo Mismatch every time I go to do a tool change. The machine won't do anything. I used M65 per the manual to no avail. Anyone have any idea how to clear this damn alarm?
Mazak issue: I keep getting an alarm of TNo Mismatch every time I go to do a tool change. The machine won't do anything. I used M65 per the manual to no avail. Anyone have any idea how to clear this damn alarm?
machine model ?
NC model?
From Fusion640MT manual Follow this procedure then in MDI input M65 "cycle start" and it should clear the mismatch error. BE CAREFUL with the first tool change after completing this.
10-11 TURRET TOOL Window
This window is used to match the pocket No. (number on the turret) with the tool No.
(1) Press the TURRET TOOL menu key.
! The display of the menu item will be reversed and the TURRET TOOL window will
appear.
(2) Place the cursor to the item where data should be inputted.
- Press the cusor key to call the cursor in the window and move the cursor to the position
where TNo. should be inputted.
(3) Enter the TNo. and press the INPUT key.
(4) Press the TURRET TOOL menu key.
! The reverse display of menu item will be cleared and the window will then disappear.