Hi
Im new to laser engravers and just purchased a CO2 40W Laser Engraving Cutting Machine W/ Laser Pointer &Laser DRW Engraver from ebay.
The machine arrived on Friday and set it up today following all the instructions in the manual and on the video. Also looked up the same type of videos on Youtube.
Checked everything over all looked ok, set the software as instructed and was all ready to switch on the laser by the main switch after having the water pump running for about 30mins.
When i turned on the main red switch to on the machine went BANG and threw my main electic box switch. Once electric was turned back on checked inside the laser and cannot see any black marks to indicate
where or what blew, water pump still works so do air assist and extractor fan. Tried changing the fuse to the main plug still nothing the machine is completely dead.
Any ideas to what went wrong, or how i can find out what blew. I know nothing about lasers at all just thought id invest in one to expand my dolls house business.
The tube seems intact and the water still pumps through it.
Any help here would be very helpful and very appreciated.
regards
Glen