Hi,
I am running v25 and I know that I am being dense about this, but I cannot get my tool path to simulate. I have done this before successfully in the past. Just cannot see what I am or not doing that I should be doing.
Thanks,
Ernie
Hi,
I am running v25 and I know that I am being dense about this, but I cannot get my tool path to simulate. I have done this before successfully in the past. Just cannot see what I am or not doing that I should be doing.
Thanks,
Ernie
Ernie,please upload a .zip of a ,bbcd file and we will be glad to get it figured out.
JR,
Please let me know how to do that.
Ernie
Ernie,,put your mouse over the closed .bbcd file,,,right click and pick send to compressed file.The compressed file is a .zip file.You will upload that by clicking the "go advanced" then pick "manage attachments" then click "browse" find the .zip file you just created and upload it.
Ok JR I will try that
Ernie,you have too large of a tool selected.Your slot is only .313,,you will need a tool smaller than .313.
Aso change your leads to "vertical"
Thanks JR, It is not supposed to be a slot it is supposed to be like a key. So I changed it to a contour and it worked.
Thanks again,
Ernie