Originally Posted by
mike^3
Hey guys, im going to retrofit my fadal to mach 3 with a motion controller to use the existing servos and drives, ill start a page called Fadal to Mach 3 conversion, im uploading some vids now...
P.S. 10k for a retrofit sounds about right, but with the extreme simplicity of fadals electronics, wiring up and setting up mach 3 will cost you 2k, and you all you existing components, maybe 5k if you get someone to install it for ya....just FYI
Yes Mach 3 does rigid tap, if you were wondering....
Good luck!