[freemanxxx]

Hello Guys,

We have a mazak H410 with mazatrol mplus, all documents that we have , We would like to Remove x,y axis driver or z axis driver from the system but we dont know how to do it

There is a rotary switch near the display of those driver, We know we need to configure it but on controller we can not find the parameters, which parameter described servo Chanel number and rotary switch channel number

We know standart meldas controller how to do it but no have experience of mazatrol

Really mý mind burn out

Help Will be very appreciate

Thank you

[freemanxxx]

Hello Guys,

We have a mazak H410 with mazatrol mplus, all documents that we have , We would like to Remove x,y axis driver or z axis driver from the system but we dont know how to do it

There is a rotary switch near the display of those driver, We know we need to configure it but on controller we can not find the parameters, which parameter described servo Chanel number and rotary switch channel number

We know standart meldas controller how to do it but no have experience of mazatrol

Really mý mind burn out

Help Will be very appreciate

Thank you

Is there any information??

[freemanxxx]

Is there any information??

we got 22 amplifier not equipment alarm so we would like to remove axis one by one to determine which driver cause problem

Any one help

[chippy1]

we got 22 amplifier not equipment alarm so we would like to remove axis one by one to determine which driver cause problem

Any one help

Is your problem resolved? Typically the drive which has the fault will display a different code then the other drives.

For instance F1 mean 1st axis then alarm code may show 22 or E7 which means emergency stop. E7 should show up on the drives which do not have any issue. The drive that has the issue will have the different code.


Chippy