Hi I have just uploaded my Probing routines for Mach3 I use them every time I start the Machine
these are xy probes and are completely automatic that is once the parameters are set it is just 1 click to probe circles id od, rectangles od id, pipes x&y, 2 points lines
The rectangles can be on the Bed at any angle all probes end up in the dead center of the object.
The probe routine's are fast because it tracks the angle of the lines and reduces XY travel.
There are 3 speed settings Rapid Fast & Slow all 3 speeds are used and I have implemented an incremental back off routine to increase speed, that is the probe only backs off
for the slow probe an amount required to reset the probe.
If a probe fails it is one click to return to the start of the probe , then adjust settings a try again.
All probe points are recorded
All probes are probe crash proof. "Well as crash proof that I can Get them" !
This is using standard Mach3 Mill screen set with an added screen for the probes
This is the first time I have published this code
I would appreciate it you Guys would give it a test.
These are everyday probes but I have coded them very different to the Normal
The accuracy is very good less than .004 mm consistently using a home brew probe.
The routine is for Metric and assumes g53z0 is at the top of the Z travel
I would really appreciate it if you Guys could give a test and give me feedback
This is a link to my dropbox with all the required files.
https://dl.orangedox.com/9jbq9GBJ3rm...rel_probes.rar
Cheers