I've use the knife edge clamps on forgings of Modified 4340, and they worked like a hot damn.
Thread: Mitee Bite clamps
Results 1 to 20 of 42
Hybrid View
-
08-03-2006, 01:04 AM #1
Registered
- Join Date
- Jun 2006
- Posts
- 629
"It's only funny until some one get's hurt, and then it's just hilarious!!" Mike Patton - Faith No More Ricochet
-
08-03-2006, 04:21 AM #2
Moderator
- Join Date
- Jan 2006
- Posts
- 4396
Mitee Bites
Have the knife set and T-Slot set. Use them all the time for anything and everything. They are great for holding irregular rectangular blocks of Aluminum that won't fit in a Vise. Also used a set in a shop I worked in a few years ago. The Feeds and Speeds were pretty High and they didn't budge .01
If you can afford them, Get Them! I got mine from a local distributer "BPT" for a good deal because they were slightly used. 
Toby D.
"Imagination and Memory are but one thing, but for divers considerations have divers names"
Schwarzwald
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
www.refractotech.com
Reply With Quote
Posting Permissions
