[y_shalom]

Hello darco30

I rely on this drawing
The most important measure is the distance between the axes (101.6 mm) .
The rest is adapted to the screw you intend to use .

Hope I helped
If you need more help or information. Do not hesitate to contact me

[daroc30]

very nice drawing , where did you get it?
thank you for the drawing it will be so useful to me.

As i can see , the yoke bore is 42mm, and the chinese 32mm 5 mm pitch ball nut has 50mm pilot diameter. Thats why i still think the 32mm chinese nut wont fit.. as i said earlier the z axis bearing housing will be in interference with the nut.

[lt00273]

Have you figured out the Yoke I have 50mm ball nuts and I need a yoke made any help would be appreciated





QUOTE=y_shalom;1850906]Hello darco30

I rely on this drawing
The most important measure is the distance between the axes (101.6 mm) .
The rest is adapted to the screw you intend to use .

Hope I helped
If you need more help or information. Do not hesitate to contact me[/QUOTE]

[lt00273]

Does anyone know someone who could machine a yoke for me a yoke for me from Fusion 360 Model

[forhire]

Does anyone know someone who could machine a yoke for me a yoke for me from Fusion 360 Model

Not that I have time... but post up your model and I'll take a look.

[service_75]

It00273 what format is your 360 drawing saved in???