Good Morning to all!
During Calibration, I want to enter the compensation values in my turning machine having Fanuuc Control. But the page where we enter the compensation values is not visible. Can anybody please help how to make visible this page?
Good Morning to all!
During Calibration, I want to enter the compensation values in my turning machine having Fanuuc Control. But the page where we enter the compensation values is not visible. Can anybody please help how to make visible this page?
What Fanuc control? What compensation values are you needing to correct? Grind pitch error, backlash, or ?
Dear ifixcnc thank you for your reply. The Fanuc Control is Series 18i. And this problem is being faced when we want to enter the Pitch Error.
In other machine we can reach to Pitch Error compensation page by soft key. But in the machine under discussion, the label of pitch error compensation is not present against that key.
On an 18 Pitch is normally under System hardkey, then arrow right or left multiple times until pitch is an softkey.
What machine is it?
Unless you have changed out an major component (ballscrew) pitch is normally not re comped.
Pitch error will not change, it is the error correction for the grinding of the ballscrew. Any wear would show up as BackLash.