[metlshpr]

I have started at a new shop as the supervisor and they have a HM 8000 with fanuc 31i-model a. The guys here have told me that the tool setter doesn't because of soft ware missing. Well, sorry but I call BS. And after contacting the salesman they have told me that there has been training done on the usage, but I am sure that the operators that are here now were not part of it as there is no long term person here anymore. Anyway to make a long story short I am looking for the instructions on usage and calibration of the tool setter. The sales man sent me a pdf for a stylus type setter (and this after I gave him the serial # (chair)) and it seems that it is becoming difficult to get anything more from them. He is wanting to send out a tech at $120/hr. Don't need that just need the instructions. So I am turning to you guys here, this place has help me a lot in the past and I know I will get some good feedback.

Thank you in advance for any help

[DouglasR]

Who made the laser setter?
I can help.
-Doug
Training Coordinator, Doosan

[metlshpr]

Renishaw Its a NC4 non contact. I did find the code from a friend that has a hm400 with the same control (M50 B1.0). And I got Renishaw on the phone for the procedure to clean the lens. I was getting error MC3092 active beam cut. The light on the top should be green it was red. After cleaning no light????? Now that I got the beam somewhat rounder I still cant use it because of the error. So now it seems to be more of a probe issue than a machine issue.

[DouglasR]

Have you talked to Renishaw?