Originally Posted by
Arbo
Unfortunately all I have done is shorten the overstep. I am down to 10% on a .25" BN. I still get them and it requires a good bit of sanding (and the paper clogs constantly). But corian cuts like butter if you have the speed and rpm's set right. I am cutting out one of the wing molds now, it's about half done at 2.5 hrs with a .25 BN, and I did not rough at all, straight to a finish cut, and the 'deepest' part on the tips, is about .75", i slow down my machine for the first couple passes that are full deep, but then put it back to 100% speed.