[jayratio]

Hi !

Our Amada Pega 357 with Fanuc 04PC Controller was set to 0+Delete+Power on, clearing all parameters.

Now the machine is not booting up, and alarm 100, 417 and 427, no lights on panel side.

The problem is that I cannot enter parameters, e.g. I can use N 005 to go to parameter No. 5 but cannot use P 00010 to enter its value.

Also I cannot change PC parameters.

Edit Protect is Off, but there is no light on Edit / MDI mode etc.

Please help URGENTLY !!

Thanks,

Ajay

[lycarem11]

Hi !

Our Amada Pega 357 with Fanuc 04PC Controller was set to 0+Delete+Power on, clearing all parameters.

Now the machine is not booting up, and alarm 100, 417 and 427, no lights on panel side.

The problem is that I cannot enter parameters, e.g. I can use N 005 to go to parameter No. 5 but cannot use P 00010 to enter its value.

Also I cannot change PC parameters.

Edit Protect is Off, but there is no light on Edit / MDI mode etc.

Please help URGENTLY !!

Thanks,

Ajay

You should press the EMG button!

[jayratio]

That worked.

Thanks a lot,

Ajay