[dbstream]

Need Nc and Pc parameters for Dainichi Lathe F35 X 1250 with Fanuc OT control. Thx

[dbstream]

Thks Guy! Parameters found. Machine is now operational.

[sanjeevkumarsr]

Hi dbstream,
I have a Dainichi F30 with Fanuc 0TF control. I bought it third hand and it has given me excellent service till now. I did not have the manuals for this machine and was foolish enough not to note down the parameter list.

I am in the same situation as you were...my parameters got corrupted due to voltage fluctuation.

I would be most grateful if you could share the NC and PC parameters of your machine. My email id is [email protected]
Thanks very much,
Sanjeev Kumar S R

[Rottita]

Hi dbstream, I have read your thread about your problem with your Dainichi F35.
Now I have the same problem and I need the nc and pc parameters. Also I need the whole programms of the control unit. I spoke with Yamazen Europe and Dainichi Japan, both couldn't help me (!!!) I hope you can help me somehow.
The lathe is: Dainichi F35 X 1250, Machin-Number: 27068.
Please contact me, I am in Germany, the company is in Hungary.
My email is: [email protected] or [email protected]
Best regards, Zsolt Wallner

[dvo17030]

Hi dbstream,
I have Dainichi Lathe F35 x 1250 with Fanuc 21-T control. Can you tell me how to save nc and nc parameter?

My email is [email protected]

Thanks