Has anyone done a conversion on the optimum mh-28 bench mill?
I have one and am looking to do a conversion.
Brett
Sent from my SM-G920F using Tapatalk
Has anyone done a conversion on the optimum mh-28 bench mill?
I have one and am looking to do a conversion.
Brett
Sent from my SM-G920F using Tapatalk
The mh28 looks almost identical to the G0704. As such, the general conversion scheme should be the same. The specs I found indicate that it is a tad bigger than the G0704 so you will have to adjust dimensions a bit, but stepper sizes and such should work fine.
That's a bf30, much bigger than a g0704. A few conversions have been done on them.
http://www.cnczone.com/forums/bencht...90088-cnc.html
Hoss
https://www.youtube.com/watch?v=HOvbzmNbtqY
http://www.hossmachine.info - Gosh, you've... really got some nice toys here. - Roy Batty -- http://www.g0704.com - http://www.bf20.com - http://www.g0602.com
It looks much like the Weiss 30LV.
I did a CNC kit for two of them. There was a casting change on the Y mount and the Y nut mounting. I stopped making the kits besause PM quit importing them.
The kit looks like this.
PM-30 Weiss 30 BF-30 by arizonavideo | Photobucket
youtube videos of the G0704 under the name arizonavideo99
I just had a look at the optimum catalogue and the MH-28 is no longer listed. They are still for sale in Australia however.... It is smaller than the BF30.