I upgraded the G0704 spindle bearings and watched 3 different G0704 videos. Hoss, RussStuff, & Franco.
My question is that after i assembled installed the new bearings and shims, I noticed I have a slight vertical slop.
If I hold the spindle housing with one hand and grasp the spindle shaft, I can move the shaft up and down a small amount.
I used the following:
Bearings from VBX.com
8891 (7007B)
8889 (7005B)
And the following shims.
McMaster-Carr
98055A346 (35x45x1 Shim) 4 shims
98089A404 (25x36x1 Shim) 3 shims
The upper and lower bearing dust covers are snug, after finger tight, i gave it another 1/8 snug/twist.
Any thoughts?