[Tompagberg]

Hi,

I´m trying to setup my newly bought cnc machine. I have a Proxxon MF70 CNC and a control box from a company called Gocnc.
I´m having some trouble figuring out how to get contact with the motors, I have watched the tutorials and I´ve set up Mach3 as they say in the video but I can't get my motors to move :/.
I have attached a few photos and maybe someone might see whats wrong. One thing that I think look strange is that not all pins are green in the diagnostics tab.

Sorry, that this is probably a very basic question. But I have very little experience with CNC´s.

Thank you!

[ger21]

Do you have the correct port address in Config > Ports and Pins?

[Tompagberg]

Thank you for your answer!
Yes I believe so. At least for the motors X,Y and Z (direction and step), I´m not to sure where and what the other pins do or should be connected, for example: Input and Output

[ger21]

No. When you go to Config > Ports and Pins, there's an address for the parallel port itself. The default is usually 0x378. Make sure that it is the correct address for your parallel port., and that Port #1 is enabled.